

Attic Roof. You have the option to buy roof tiles to complement the Carver Lane kit. I have them and they will be instrumental in covering a multitude of my construction sins. However, I want to build these attic windows is if they are not going to be tiled. I will be paying special attention to the apex, where the two roof sections meet the ridge. Remember, every edge on these MDF pieces is strictly right angles.
Look at the second picture below. It shows the ridge piece. Notice that where it extends past the front wall there is a cut out section. This is to allow the straight edge of the roof section to slide underneath. In my dry fit tests I could not get a consistent fit on all four roof pieces. Given this is my ‘experimental model’ I decided to try two different fitting methods. On one ridge line I am going to give the roof sections a chamfered edge. I will leave the original 90° facing on the other roof sections. The difference will be insignificant I’m sure but I can’t help myself. It will also be invisible once the tiles and ridge capping are applied.

Glue in the attic modules first and wait for them to dry before fitting the ridge beam. Wait for that to dry. You want a firm work surface when positioning the roof sections. I will use super glue on one roof and PVA on the other. Will the super glue grab before I can position the roof section? Will PVA allow the roof section to slide before it holds it in position? I’ll be back.
So the PVA worked for the affixing the basic attic box and ridge beam. But it was messy. The judges are still out on the question of PVA vs Super Glue. I used blue paint tape to dry fit the roof sections and after several tests I kept it on to lay the sections with glue. I used super glue to fix the roofs and that was a damned mess as well. You can see the spots on the main roof and the little stream of glue running down from the left attic window. I think the PVA is too thin for a sloping surface but if I use Super Glue it will have to be a gel product.
Chamfer vs straight edge? Can you see any difference? I can (a little) but I know which is which. Hint: on the Carver Lane #2 project I will not bother chamfering the edges.




